Modeling ExB drift transport in conceptual slot divertor configurations

At DIII-D, a slot divertor concept, called small-angle-slot (SAS), is under development, aiming to enable detachment at relatively low plasma edge density. We report on simulations using the SOLPS-ITER two-dimensional edge code to examine the performance of conceptual “SAS 2” slot configurations. The focus of the analysis is on E  ×  B drift effects on upstream density at detachment (UDD), with detachment marked by electron temperature T_e ≤ 3 eV at the outer strike point (OSP). With toroidal field such that radial E  ×  B drift carries particles from the OSP towards the private flux region (PFR), placing the OSP near the inner slot wall gives ≈20% lower UDD than having the OSP near the outer wall. The inner wall effectively traps the radial E  ×  B drift flux, resulting in low T_e and associated radial electric field in the PFR, and thus small losses from the slot to the inner target via poloidal E  ×  B drift flux. With toroidal field reversed such that radial E  ×  B drift is reversed, OSP placement near the inner wall gives ≈10% lower UDD than OSP placement near the outer wall. Although radial E  ×  B flux is from the OSP towards the outer wall, this flux largely escapes the slot, raising the UDD. A change in the slot shaping is suggested with the goal of eliminating such E  ×  B -driven particle losses from the slot.     

传输线方程的高精度龙格−库塔数值求解方法

提出了一种求解传输线方程的高精度龙格-库塔(RK)方法。此方法在空间上采取高阶泰勒展开,提高了对空间微分的近似精度,减少了数值色散所带来的误差。与传统的时域有限差分法(FDTD)方法相比,在每波长采样数相同时,RK方法的计算精度更高。同时,根据Taylor模型,对外界平面波激励源进行离散,成功利用RK方法对外部场激励传输线进行求解,扩大了龙格-库塔方法在求解传输线方程时的应用范围。通过编程对平面波辐照下无限大地平面上的单导体与双导体的算例分别应用FDTD方法与RK方法进行了计算,验证了RK方法的正确性。结果表明同等计算条件下RK方法的计算精度更高。     

表面喷砂对有机玻璃沿面闪络性能影响

绝缘子表面粗糙处理是提升其沿面闪络性能的重要途径,表面粗糙化处理方式不当,极易带来表面结构不均匀,难以获得稳定耐压性能的绝缘材料。为提升绝缘子表面粗糙处理的均匀性,本文利用表面喷砂技术对圆柱形有机玻璃(PMMA)绝缘子进行了粗糙化处理研究,以球形二氧化硅(SiO2)颗粒为工作介质,研究了不同喷砂粒径、氢氟酸后处理等因素对绝缘材料表面形貌和组分的影响,并利用短脉冲高压测试平台对喷砂处理前后有机玻璃绝缘子样品进行了真空沿面闪络性能测试。研究结果表明,喷砂处理在有机玻璃表面形成了较为均匀的凹坑,HF酸能够有效去除表面残留的SiO2颗粒,具有表面喷砂粗糙结构的绝缘子沿面闪络电压得到了稳定提升,相较于未处理的绝缘子闪络电压提升了约80%。     

平面波输入下海水-海床-结构动力相互作用分析

海洋工程结构的地震反应分析是保证海洋工程结构地震安全的重要环节.由于其所处的复杂环境, 该问题涉及到流固耦合和土-结相互作用.本文基于海水、饱和海床、基岩流固耦合统一计算框架,采用Davidenkov模型和修正的Masing准则考虑饱和海床的非线性,在脉冲SV波垂直入射下, 进行了海域场地和海洋工程结构的动力响应分析. 首先,对比分析了线性自由场和非线性自由场输入情形的海域场地非线性反应,结果表明线性自由场输入时反应不合理,自由场分析和场地分析应该采用相一致的本构模型. 然后,对比分析了海床分别为线性和非线性情形时,海域场地以及海水-海床-结构体系的反应特征. 与线性海床情形相比,非线性对海床反应的影响主要由如下两方面因素控制: 一方面,非线性导致饱和海床模量减小, 饱和海床与基岩间的波阻抗比减小,由基岩到饱和海床间的反射系数和透射系数增加, 导致反应增大; 另一方面,非线性导致阻尼加大, 使海床反应减小. 对于本文算例而言,阻尼对非线性海床结果的影响占主导作用.      

The Jordan property of Cremona groups and essential dimension

We use a recent advance in birational geometry to prove new lower bounds on the essential dimension of some finite groups.     

Application of ion-imprinted polymer synthesized by precipitation polymerization as an efficient and selective sorbent for separation and pre-concentration of chromium ions from some real samples

In this study, a new Cr(III)-imprinted polymer (Cr(III)-IIP) is prepared from CrCl₃·6H₂O, methacrylic acid functional monomer, ethyleneglycoldimethacrylate cross-linking agent, 2,2?-azobisisobutyronitrile radical initiator and 2,2-(azanediylbis (ethane-2,1-diyl))bis(isoindoline-1,3-dione) ligand. To obtain the maximum adsorption capacity, the optimum condition was studied through pH, type and concentration of eluent, IIP weight, sample volume as well as the adsorption and desorption times. The Cr(III) ion content was determined via flame atomic absorption spectrometer. In optimum conditions, the adsorption capacity of the IIP for Cr(III) was obtained to be 74.65 mg g^?1, using 50 mg of IIP and the initial pH solution of 3.0. Both the adsorption and desorption times for quantitative analyses of Cr(III) ions were 15 and 5 min; respectively. After elution of the adsorbed ions by 3 mL of 4 mol L^?1 HNO₃ aqueous solution, the established IIP-based SPE procedure provides a reasonable pre-concentration factor of 100. The IIP-based pre-concentration method provides a low detection limit of 1.7 µg L^?1 with good repeatability (RSD?=?3.22%). Reusability studies confirmed that synthesis IIP is reusable and recoverable up to six cycles. According to the selectivity experiments, it was concluded that the prepared sorbent possesses more affinity toward Cr(III) ions than other ions such as Al³⁺, Pb²⁺, Cu²⁺, Mn²⁺, Fe²⁺, Zn²⁺, and Ni²⁺ ions. To evaluate the potential applicability of the proposed separation method, the pre-concentration and determination of trace amounts of Cr(III) were performed successfully in food samples with complex matrices, a bestial sample (i.e. cow liver) and an herbal product (i.e., broccoli) as real samples.     

On the output function in a Ginsburg’s machine

We give the form of the output function in Ginsburg’s machine in which the input and output dictionaries are abelian groups and the transition function is of a special form.     

Rotating Detonation Combustor Research at the University of Cincinnati

Rotating detonation combustors (RDC) are at the forefront of pressure gain combustion (PGC) research. The simplicity in design and the ease of assembly makes it a promising technology that could be integrated into existing combustor architectures. This is, however, coupled with the considerable complexities of the detonation-based flow field, and the associated modes and coupling mechanisms. The current paper is an overview of the research done at the University of Cincinnati to address some of the challenges and questions pertaining to the physics of RDC operation. Issues such as combustor geometry, injection schemes and mixing, varied reactants behavior and modes of RDC operation are discussed. The effects of pressurization of the combustor, along with other detonation enhancement strategies are also deliberated upon. When appropriate, parallels are drawn to the phenomena of high frequency combustion instabilities to address the similarities in observations between the two fields.     

Integral Group Rings With All Central Units Trivial: Solvable Groups

The object of this paper is to examine finite solvable groups whose integral group rings have only trivial central units.